LSI MegaRAID Enterprise 1600 - Manual (Page 69)

Chapter 6 Hardware Installation 55
Step 5 Set Jumpers, Continued
J14 Serial Port J14 attaches to a serial cable. The pinout is:
Pin Signal Description Pin Signal Description
1 Carrier Detect 2 Data Set Ready
3 Receive Data 4 Request to Send
5 Transmit Data 6 Clear to Send
7 Data Terminal Ready 8 Ring Indicator
9 Ground 10 CUT
J19 Onboard BIOS Enable J19 is a 2-pin berg which enables or disables MegaRAID onboard BIOS. The onboard
BIOS should be enabled (J19 unjumpered) for normal board position.
J19 Setting Onboard BIOS Status
Unjumpered Enabled
Jumpered Disabled
J17 Dirty Cache LED J17 is a two-pin connector for an LED mounted on the computer enclosure. The LED
indicates when the data in the cache has yet to be written to the storage devices.
Pin Description
1 High
2 Dirty Cache Signal
J23 External Battery J23 is a 5-pin berg that attaches to the optional battery pack. The J23 pinout is:
Pin Signal Description
1 +BATT Terminal (red wire)
2 Thermistor (white wire)
3 -BATT Terminal (black wire)
4 BATDQ (no wire)
5 Ground (no wire)
Cont'd