Kenwood TM-V71E - Manual (Page 54)

46
3 Rotate the Tuning control to select a group to link.
4 Press the Tuning control to set the group and move the cursor to the right.
• Press [REV] ( ) to move the cursor back or [LOW] ( ) to move the cursor to the
right.
5 Repeat steps 3 and 4 to link additional groups together.
6 When you have entered your desired groups, press [LOW] ( ) to move the
cursor to the right, then press the Tuning control to complete the entry and
exit Menu mode.
• If you have entered the maximum of 6 groups, simply press the Tuning control to
complete the entry and exit Menu mode.
PROGRAM SCAN
Program Scan is identical to VFO Scan except that you select a frequency range
for the scan.
n Setting Scan Limits
You can store up to 10 scan ranges in Memory channels L0/U0 to L9/U9.
1 Press [VFO].
2 Select your desired band.
3 Rotate the Tuning control to select your desired frequency for the lower
limit.
4 Press [F].
• A memory channel number appears and blinks.
5 Rotate the Tuning control to select a channel from L0 to L9.
6 Press [MR] to set the channel number.
• The lower limit is stored in the channel.
7 Rotate the Tuning control to select your desired frequency for the lower
limit.