Kodak 5300 - Manual (Page 24)

Chapter 2
select photos with your camera, the camera creates a DPOF file that identifies which photos have been
tagged for printing. Your Kodak EasyShare AiO can read the DPOF file from the memory card in a camera
so you do not have to re-select the photos to print.
NOTE: Not all digital cameras allow you to tag your photos for printing. See your digital camera
documentation to see if it supports tagging (DPOF).
When you print tagged photos, the selected default layout is applied, unless your camera allows selection
of sizes.
The DPOF file is stored by the digital camera on a memory card and specifies the following information:
Which photos to print
The quantity of each photo to print
Index printing (thumbnails of selected photos)
The default setting for using a detected DPOF file is Yes.
1 Press Menu to display the main menu.
2 Press
b
to select Photo Print Settings.
3 Press OK.
4 Press
b
to select Use Print Order if Found.
5 Press
_
or
`
to change the setting.
6 Press OK.
Scene balance
Your EasyShare AiO can be configured to apply automatic scene balance improvements (brightness) for
photos printed on the AiO from memory cards and USB connected devices.. The default is to apply the
scene balance improvements.
1 Press Menu to display the main menu.
2 Press
b
to select Photo Print Settings.
3 Press OK.
4 Press
b
until Scene Balance is selected.
5 Press
_
or
`
to enable or disable Scene Balance.
6 Press OK.
Add Date to Prints
You can set your EasyShare AiO to print the date a picture was taken on the photo print. The default is to
not print the date.
1 Press Menu to display the main menu.
2 Press
b
to select Photo Print Settings.
3 Press OK.
20 Kodak EasyShare 5300 AiO