Kodak 5300 - Manual (Page 18)

Chapter 2
7 Insert the colour ink cartridge into the printhead.
8 Press down firmly on the cartridge until you hear it snap into position.
9 Close the printer access door.
NOTE: For the best quality prints, store ink cartridges in a location where the temperature does not
exceed 30°C (85°F).
Install the duplexer
The Kodak EasyShare AiO supports an optional duplexer (Kodak EasyShare 5000 Series two-sided
printing accessory) that enables printing on both sides of the paper. When installed, the duplexer is
automatically detected by the printer and computer system software.
The duplexer is limited to plain paper (no photo paper). The paper dimensions that can be used are from
17.5 to 21.6 cm (6.9 to 8.5 inches) wide and from 24.9 to 29.7 cm (9.8 to 11.7 inches) long.
You can purchase a duplexer and other accessories for your printer at www.kodak.com/go/accessories .
1 Remove the door on the back of the printer by pressing in on the two latches and pulling out.
14 Kodak EasyShare 5300 AiO