beautypg.com

In case of difficulty – Kenwood MDX-G1 User Manual

Page 56

background image

56

EN

In case of difficulty

What seems to be a malfunction is not always so. Before calling for service, check the follow-
ing table according to the symptom of your trouble.

Operation to reset

The microcomputer may fall into malfunction when a cord is unplugged and plugged again while the
unit is ON or due to an external cause. In such a case, the microcomputer should be reset as described
below:

Unplug the power cord from the wall outlet and, while holding the ON/STANDBY

key

depressed, plug the power cord again. This initializes the microcomputer. Note that this clears
the previously stored memory.

Common section

Sound is not produced.

\ Increase the volume level. (page 11)
\ Unplug the headphones if they are connected. (page 6)

No sound from the headphones.

\ Check if the headphone plug is inserted properly into the jack. (page 6)

Noise interferes.

\ Install the outside antenna more apart from the streets. (page 5)
\ Turn nearby electrical appliances off.
\ Install the audio system more apart from the TV set or personal computer.

Amplifier / Speaker section

The clock display blinks without changing the figures.

\ Adjust the present time again. (page 7)

Timer operation is not possible.

\ If the present time has not been adjusted or there was a power failure, adjust the present

time. (page 7)

\ Set the timer ON time and OFF time. (pages 45 to 51)

Radio stations cannot be received.

\ Connect the provided AM loop antenna to the AM ANTENNA jack. (page 5)
\ Extend the FM rod antenna and orient it to the direction in which best reception is obtained.

(page 5)

\ Select the correct broadcast band. (pages 8 to 9)
\ Tune to the frequency of the desired station. (page 9)

After a radio station is preset, it cannot be received by pressing the

4 P.CALL or ¢ P.CALL

button.

\ Preset stations with tunable frequencies. (pages 8 to 9)
\ If the preset memory has been cleared because the power cord has been unplugged for a

long period, preset the stations again. (pages 8 to 9)

*5053/52-64/EN

5/29/01, 11:02 AM

56