Kenwood MDX-G1 - Manual (Page 32)

32 EN
Remote control unit only
1
Make preparation for recording.
MD : See steps 1 to 3 of “Recording
CD onto MD” (page 16 to 17).
2
Program the CD tracks in the de-
sired sequence.
See steps 1 to 5 of “Playing CD or
MD tracks in the desired sequence”
(page 24).
3
Start recording.
Recording onto MD : Press the MD
O.T.E. key.
To stop recording :
Press the 7STOP key.
÷ Be careful not to switch the power off or
apply shock or vibrations to the system while
“MD WRITING” is displayed.
÷ When recording with high volume, sound
skip may occur during MD playback. To avoid
this problem, reduce the volume during re-
cording.
Recording CD tracks onto
MD in desired sequence
The tracks in a CD can be recorded by rear-
ranging them in the desired sequence when
the recording speed is normal (CD
=MD
NORM). Note that this function is not avail-
able when the recording speed is high
(CD
=MD HIGH).
Recording onto MD (continued)
With regards to track numbers at
the time of recording
MD track numbers are used to search the
beginning of a track or programming tracks.
÷ In MD recording from the radio, AUX or
CD source, track numbers are assigned
automatically in the following cases.
– When the MD
6 or MD REC key is
pressed in record-pause mode to
resume recording.
– When the MD EDIT key on the remote
is pressed during recording.
POWER
FM / AM CD 6 MD 6
MD O.T.E.
P. CALL ¢ P. CALL 4
TUNING fi
1 TUNING %
¡
SLEEP
7 STOP
VOL.
MD O.T.E.
7 STOP
*5053/28-33/EN 5/29/01, 11:00 AM 32