Kenwood TK-5310 - Manual (Page 62)

54
S
ite
t
runking
On Trunking channels, if set up by your dealer, the transceiver
will indicate a network condition on the registered site. On K2/
K3/K5/K6/K7 model transceivers, “SITE TRUNK” appears on
the display when the transceiver receives a network disabled
message.
c
ontrol
c
hAnnel
h
unt
On Trunking channels, the transceiver must search for a
control channel. While searching for a control channel, no
signals can be received. The search begins automatically
when you change to a Trunking channel.
• On K2/K3/K5/K6/K7 model transceivers, while hunting for a
channel, the antenna icon will flash. When a control channel
has been found, the antenna icon remains on the display without
flashing.
v
oice
A
nnunciAtion
When changing the zone and/or channel, an audio voice will
announce the new zone and channel number. The Voice
Annunciation will not function when using the VGS- option
{page 55}. (Voice Annunciation can be enabled or disabled by
your dealer.)
ptt id
PTT ID is the transceiver unique ID code which is sent each
time the PTT switch is pressed.
Note: PTT ID can be made only in FM Operation.
If Beginning of Transmit is set, the ID signal is transmitted
when you press the PTT switch.
If End of Transmit is set, the ID signal is transmitted when you
release the PTT switch.
If both are set, the ID signal is transmitted when you press and
release the PTT switch.