Kodak Digital Photo Frame - Manual (Page 66)

59 www.kodak.com/go/support
Changing settings and more
2 Highlight Clock and timer, then tap Select.
3 Highlight On/Off schedule, then tap Select.
The current time is displayed and the hour field is highlighted.
4 Set the Turn on time. Slide to adjust the hour. Tap the Next arrow to highlight the
next setting (minutes), then slide to adjust it. Repeat to set Turn off time.
NOTE: Make sure the on time is earlier than the off time.
5 Tap Enable, then tap Save when you’re done.
Your frame will now automatically turn on and off at the times you specified.
If your frame loses power, the clock time returns to the factory setting and the
automatic on/off times, if set, are disabled. To reset the clock and re-enable your
on/off times, see
Resetting the clock after losing power, page 66 .
Upgrading your firmware (recommended)
Firmware is the software that runs on your frame. To check for the latest version, visit
www.kodak.com/go/digitalframedownloads .
Automatically upgrade firmware from the Internet
When the frame is connected to your wireless network, you receive an automatic
notice from the Internet whenever a new firmware version is available for your frame.
When the notice appears, select one of the screen options:
■ Install now (to upgrade right away)—Select, then press OK to start the upgrade.
When the upgrade is complete, your frame automatically restarts. If it doesn’t, press the
power switch on the frame to Off, then back to On.
IMPORTANT: Do not turn off the frame during the upgrade!
■ Remind me later (to upgrade later)—Select, then press OK.
The upgrade message disappears, then appears again the next time you turn on the
frame.
■ No thanks (to dismiss the message)—Select, then press OK.