5) removing the torque limiter, D-27 – Konica Minolta PagePro 1390 MF User Manual

Page 69

D-27

(5)

Removing the Torque Limiter

1. Remove the Paper take up Clutch Gear.

Precautions for Installation of the Torque Limiter
The Coupling Gear has five notches for adjustment of the Take-up Roller position. When

the Torque Limiter is replaced, adjust the set position of the Coupling Gear so that the Take-

up Roller becomes level. The procedure is as follow.

Look at the stop position of the Take-Up Roller from the Clutch Gear side.

20. Unhook two tabs and remove the Paper Take-Up

Clutch Gear.

4136D057AA

2. Unhook three tabs and take apart the Paper

Take-Up Clutch Gear then, remove the Torque

Limiter.

4136D043AA

Torque Limiter

Coupling
Gear

4136D044AA

After replacing the Paper Take-Up Clutch Gear

(Torque Limiter) on the shaft, rotate the Paper Take-

Up Clutch Gear by hand (the Solenoid Flapper needs

to be released).

4136D060AA