Konica Minolta PagePro 1390 MF - Manual (Page 40)

E-8
(3) Replacing the Fusing Unit
NOTE
• Immediately after turning off the printer, the area around the Fusing Unit is extremely hot.
Therefore, in order to reduce the risk of burns, wait until the unit has cooled down before
performing any operation.
1. Remove the IR Unit.
☞ D-18
2. Remove the Exit tray.
☞ D-2
3. Remove four screws and the Upper Cover.
4558F2C022DA
4. Remove two screws, unplug three connectors,
and remove the Fusing Unit.
NOTE
• The surfaces around the Fusing Unit are very hot.
Use the utmost care not to touch any surfaces
other than the Fusing Unit.
4980E002AB
5. Remove the Fusing Unit.
4980E003AA