Konica Minolta PagePro 1390 MF - Manual (Page 36)

E-4
(3) Replacing the Image Transfer Roller
1. Lift up the Exit Tray and remove it.
2. Open the Front Door.
3. Remove the Imaging Cartridge.
☞ E-5
4. Press down the levers of the white bushings (one
on the right end and one on the left end of the
Image Transfer Roller) and slide the Image Trans-
fer Roller out of the Image Transfer Roller holder.
4136E018AA
5. Remove the two bushings (one on the right end
and one on the left end) and the gear from the
Image Transfer Roller.
6. Install the bushings and the gear in the new
Image Transfer Roller.
NOTES
• Do not touch, or dirty with chemicals or toner, the
surface of the Image Transfer Roller, as indenta-
tions in and dirt on the surface of the Image Trans-
fer Roller adversely affect the quality of the printed
image.
• When handling the Image Transfer Roller, hold
onto the shaft and bushings of the roller.
• Do not place a new Image Transfer Roller directly
on the floor or other surface.
4136E019AB
7. Insert the new Image Transfer Roller into the
Image Transfer Roller holder and push the levers
of the bushings into their original upward posi-
tions.
4136E020AB