Kodak 6B6640 User Manual
Page 57
Using Additional Calibration Features
March 2001
3-27
Editing Information on the Procedure Tab
The Procedure tab contains general configuration attributes as shown and
described below. The values displayed in the example are the default settings.
To edit the configuration information on the Procedure tab:
1.
Use the drop-down lists to change the Procedure information as needed.
2. If you have completed all editing (including information on the other tabs),
click OK to save the changes and close the Edit Configuration window. (Or,
click Cancel to cancel all changes.)
3. To continue making changes to the Edit Configuration, click another tab and
make changes as needed.
Procedure
Attribute
Description
Graphing
Instructs the application when to display the graphs of the data
Tolerance Level
Indicates whether the level of tolerance is Normal, Loose, Strict, or ColorMetallic
Normal.
NOTE: ColorMetallic paper requires its own tolerance file.
Out of Tolerance
Provides the flexibility to interact at each step or to use a fully automated calibration
Maximum
Cycles
Indicates the maximum number of iterations the calibration procedure will perform if
“Out of Tolerance” is set to “Automatically iterate up to maximum cycles.”
Processor In
Control
Indicates whether the Processor In Control dialog box is to be displayed at the
beginning of the calibration process