Kenwood KDC-448U - Manual (Page 52)

52 |
KDC-X895/ KDC-BT848U/ KDC-X595/ KDC-448U
Bluetooth setup
Function of KDC-X895, KDC-BT848U, KCA-BT300/BT200 (Optional Accessory)
Bluetooth detail setting
Configures initial settings of this unit.
1
Enter Bluetooth mode
KDC-X895 KDC-BT848U
Press the [ ] button.
KDC-X595 KDC-448U
Press the [LOG] button for at least 1 second.
“BT MODE” is displayed.
2
Enter Function setting mode
Press the Control knob for at least 1 second.
3
Select Bluetooth detail setting mode
The item can be selected and determined as
follows.
“Settings”
> “Detailed Settings”
To select the item, turn the Control knob. To
determine the item, press the Control knob.
4
Select the desired Bluetooth detail setting
item
Turn the Control knob to select Bluetooth detail
setting item, and then press the Control knob.
Display Overview
“Detailed Settings”
“Auto Answer” This function automatically answers (responds
to) a call after lapse of the preset time interval
for automatic answer.
“OFF”: Does not answer the phone call
automatically.
“0”: Automatically answers the phone call
at once.
“1SEC” – “8SEC” – “99SEC”:
Automatically answers the phone call after
lapse of 1 – 99 seconds.
“Auto Reconnect” When “ON” is selected, re-pairing with the
registered Bluetooth device starts automatically
when pairing is disconnected.
“ON” / “OFF”
“Bluetooth HF”
“Bluetooth HF/
Audio”
You can specify output speakers for hands-free
voice communication and Bluetooth audio
sound.
“Front” : Outputs sound from the front
speakers.
“All” : Outputs sound from the front and rear
speakers.
“Call Beep” You can output a beep from the speaker when
a call comes in.
“ON” : Beep is heard.
“OFF” : Beep is canceled.
“MIC Gain” Adjusts the sensitivity of the built-in
microphone for a telephone call. Adjust the
voice of caller. Setting to “+” increases the
voice volume.
Function of the KDC-X895, KDC-BT848U
“-3” – ”0” – “+3”
“NR Level” SReduces the noises generated by surrounding
environment without changing the built-in
microphone volume. Adjust the voice of caller
when it is not clear. Setting to “+” increases
the noise reduction.
Function of the KDC-X895, KDC-BT848U
“-3” – ”0” – “+3”
“Echo Cancel” Sets the echo cancellation level.
Function of the KDC-X895, KDC-BT848U
“-2” – ”0” – “+2”
( : Factory setting)
5
Set the Bluetooth detail setting item
Turn the Control knob to select desired value,
and then press the Control knob.
The previous item is displayed.
6
Exit Function setting mode
Press the [
] button for at least 1 second.