Kenwood KDC-448U - Manual (Page 48)

48 |
KDC-X895/ KDC-BT848U/ KDC-X595/ KDC-448U
Downloading the Phone book
Download the phone book data from the cell-
phone to this unit so that you can use the Phone
Book of this unit.
Downloading automatically
If the cell-phone supports a phone book
synchronization function, the phone book is
downloaded automatically after Bluetooth
connection.
⁄
• Setting on the cell-phone may be required.
• If no phone book data is found in the unit even after the
“Completed” is displayed, your cell-phone may not support
automatic download of phone book data. In this case, try
downloading manually.
Downloading from the cell-phone manually
1
Operate the cell-phone to end the hands-free
connection.
2
Operate the cell-phone to send the phone
book data to this unit
By operating the cell-phone, download the phone
book data to this unit.
• During downloading:
“Downloading” is displayed.
• After completion of downloading:
“Completed” is displayed.
3
Operate the cell-phone to start the hands-free
connection.
Clearing the downloading completion message
Press any button.
⁄
• Up to 1000 phone numbers can be registered for each
registered cell-phone.
• Up to 32 digits can be registered for each phone number
along with up to 50* characters representing a name.
(* 50: Number of alphabetic alphabetical characters.
Fewer characters can be input depending on the type of
characters.)
• To cancel downloading of the phone book data, operate
the cell-phone.
Bluetooth setup
Function of KDC-X895, KDC-BT848U, KCA-BT300/BT200 (Optional Accessory)
Selecting the Bluetooth device you
wish to connect
When two or more Bluetooth devices have already
been registered, you need to select the Bluetooth
device you wish to use.
1
Enter Bluetooth mode
KDC-X895 KDC-BT848U
Press the [ ] button.
KDC-X595 KDC-448U
Press the [LOG] button for at least 1 second.
“BT MODE” is displayed.
2
Enter Function setting mode
Press the Control knob for at least 1 second.
3
Select Bluetooth device selection mode
The item can be selected and determined as
follows.
“Settings”
> “Pairing” > “Phone Selection” (to
select the cell-phone) or “Audio Selection” (to
select the audio player)
To select the item, turn the Control knob. To
determine the item, press the Control knob.
“(name)” is displayed.
4
Select a desired Bluetooth device
Turn the Control knob to select Bluetooth
device name, and then press the Control knob.
‘✱(name)’ or ‘-(name)’ is displayed.
“✱”: The selected Bluetooth device is busy.
“-”: The selected Bluetooth device is on standby.
“ “ (blank): The Bluetooth device is deselected.
5
Exit Bluetooth mode
Press the [SRC] button.
⁄
• If a cell-phone is already selected, deselect it, and then
select a different one.
• If you cannot select a device using the audio player,
connect the device with the audio player.