Kenwood HM-582MD User Manual
Page 28
28
Preparation section
Basic section
Apprication section
Knowledge section
Receiving broadcast station
1 Press the TUNER/BAND key to select “FM” or
“AM”.
Tuning a non-preset radio station (Auto tuning, Manual tuning)
To decrease
frequency
To increase
frequency
“AUTO”
“MANUAL”
Each press of the key alternates these tuning
modes.
Normally, use the “AUTO” (Auto tuning) mode.
TUNER/BAND
PGM
/CHARAC.
AUTO/MONO
AU TO
STEREO
TONE
A.P.S.
12:30PM
MAN
UAL
TONE
A.P.S.
12:30PM
3 Press the 1,¡ key to receive a station.
2 Press the PGM/CHARAC. key to select auto tun-
ing or manual tuning.
1
1
TUNING
÷ Use the manual tuning mode when reception is noisy due to
weak reception. (In the manual mode, stereo broadcasts are
received in monaural.)
Auto tuning mode :
Each press receives a new station.
Manual tuning mode :
Press repeatedly until the desired station is re-
ceived.
÷ Repeat steps 1~4 to preset other stations.
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
One-by-one presetting (manual preset)
1 Perform the procedure in “Tuning a non-preset
radio station” to receive the station you want to
preset.
ENTER
ENTER
FM P03
90.00MHz
MEMORY
3 Select the desired preset number between 1 and
40 using the numeric keys on the remote control
unit.
4 Press the ENTER key.
2 Press the ENTER key during reception.
FM P--
90
00MHz
MEMORY
Blinks
Lights
The preset operation is canceled when no key has been
pressed for more than 20 seconds during operation.