Kenwood HM-582MD - Manual (Page 15)

Menu mode
15
Knowledge section
Preparation section
Application section
Basic section
Contents
Example for adjusting at
1:30PM
1 Adjust the figure of hour by rotating the volume/
multi-control knob.
2 Press the set key.
1 Adjust the figure of minute by rotating the vol-
ume/multi-control knob.
2 Press the set key.
Enter the minute.
Enter the hour.
This unit incorporates a clock function. Be sure to
adjust the correct time before using the timer func-
tion.
1
Activate the clock adjustment mode.
2
3
Clock adjustment
÷ The time display starts to blink.
÷ Press the set key. The hour is entered and the minute display
starts to blink.
÷ If you pressed the set key by mistake, press the menu/
demo key and restart from the beginning.
÷ To adjust correct time, press the set key at the same moment
as a time announcement.
1 Press the menu/demo key.
2 Rotate the volume/multi-control knob to select
“TIME ADJUST ?”, then press the set key.
3 Select “12 HOUR” or “24 HOUR” by rotating the
volume/multi-control knob, then press the set
key.
2 Select “TIME ADJUST ?”
Blinks
Blinks
Blinks
1
Setting the hour
1 Setting the minute
When power is OFF (standby) :
Press the
7 STOP key to display the time of the day
for 5 seconds.
To put back
the time To advance
the time
To put back
the time To advance
the time
Switching the power ON
menu/demo
7 STOP
set
7 STOP
volume/
multi-control
volume/
multi-control
s
e
t
s
e
t
T
IME
A
DJUST
1:00
PM
0
TONE
T
IME
A
DJUST
00 ?
12:00
PM
0
T
IME
A
DJUST
1:30
PM
TONE
T
IME
A
DJUST
12 : H
OUR
‰
If there is a power failure or the power cord is
unplugged then plugged in again while the power
set to off (STANDBY mode) after a timer is activated,
the /timer indicator blinks in amber.
In this case, adjust the clock again.
3 Select the time display mode.
÷ The time of the day is represented in 12-hour or 24-hour
method.
Blinks
volume/
multi-control