Kenwood HM-582MD - Manual (Page 17)

Menu mode
17
Knowledge section
Preparation section
Application section
Basic section
Contents
The contrast of the LCD display on the main unit
can be switched as desired.
Blinks
LCD contrast adjustment (CONTRAST)
÷ Adjust the contrast when the LCD display is hard to read
due to a problem in the installation position or to the
ambient temperature condition, etc.
TIME
/SPACE
C
ONTRAST
?
C
ONTRAST
–
00000 • • • • • • • • • • +
TONE
CD 0 03
0 MY Bestso ‰
TONE
S
CROLL
M
IDDLE
My Bestson
TONE
B
ACK
0 L
IGHT
00 ?
0HIGH ‰
B
ACK
0 L
IGHT
0
0 HIGH
‰
TONE
If the LCD display is hard to view (due to too high or low
contrast), press and hold the display key on the main unit
for more than 2 seconds. This resets the contrast to the
initial value.
The brightness of the back light of the LCD panel can
be switched as desired.
Blinks
LCD back light adjustment (BACK LIGHT)
Blinks
LCD scroll speed adjustment
÷ Adjust the contrast when the LCD display is hard to read
due to a problem in the installation position or to the
ambient temperature condition, etc.
When CD text or MD title characters scrolled on the
LCD panel are hard to read, the scrolling speed can
be switched as desired.
Title display mode
1Press the TIME/SPACE key repeatedly to enter
title display mode.
Select the “CD“ or “MD“ input. )£
Title is scrolled.
2 Press and hold the TIME/SPACE key for more
than 2 seconds.
3 Repeat step 2 until the desired scroll speed is
selected.
Pressing and holding the TIME/SPACE key for more than
5 seconds resets the scroll speed to the initial value.
“SCROLL FAST +“ High speed
(Initial value)
“SCROLL MIDDLE“ Middle speed
“SCROLL SLOW“ Slow speed
The scroll speed is switched every time the
operation is repeated.
1 Press the menu/demo key.
2 Rotate the volume/multi-control knob to select
“CONTRAST ?”, then press the set key.
3 Select the desired brightness (display density)
by rotating the volume/multi-control knob, then
press the set key.
TIME
/SPACE
1 Press the menu/demo key.
2 Rotate the volume/multi-control knob to select
“BACK LIGHT ?”, then press the set key.
3 Select “LOW” or “HIGH” by rotating the vol-
ume/multi-control knob, then press the set key.