Kenwood TK-5320 - Manual (Page 31)

8
• Select “ALL” Fleet and “ALL” ID to make a call to all units
(Broadcast call).
S
tAtuS
m
eSSAge
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to
alphanumeric characters. Status messages range from 0 to
(80 ~ are reserved for special messages).
A maximum of received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
mode (proceed to step ) or Selcall + Status to enter
Selcall mode (proceed to step 3).
3 Press / to select the station you want to call.
• If Manual Dialing is enabled, you can enter a station ID by
using the DTMF keypad.
4 Press to enter Status mode.
5 Press / to select the status you want to transmit.
• If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad.
6 Press the PTT switch or Side 2 key to initiate the call.
• “” appears on the display when the status
has been successfully transmitted.
■
Receiving
The icon will flash and a calling ID or text message will
appear when a Status call is received. Press any key to
return to normal operation.