Kenwood TK-5320 - Manual (Page 10)

v
• Do not charge the battery near fires or under direct
sunlight!
If the battery’s protecton crcut s damaged, the battery may
charge at extreme current (or voltage) and an abnormal
chemcal reacton may occur. The battery may generate heat or
smoke, rupture, or burst nto flame.
• Use only the specified charger and observe charging
requirements!
If the battery s charged n unspecfed condtons (under hgh
temperature over the regulated value, excessve hgh voltage
or current over regulated value, or wth a remodelled charger),
t may overcharge or an abnormal chemcal reacton may occur.
The battery may generate heat or smoke, rupture, or burst nto
flame.
• Do not pierce the battery with any object, strike it with an
instrument, or step on it!
Ths may break or deform the battery, causng a short-crcut.
The battery may generate heat or smoke, rupture, or burst nto
flame.
• Do not jar or throw the battery!
An mpact may cause the battery to leak, generate heat
or smoke, rupture, and/or burst nto flame. If the battery’s
protecton crcut s damaged, the battery may charge at an
abnormal current (or voltage), and an abnormal chemcal
reacton may occur.
• Do not use the battery pack if it is damaged in any way!
The battery may generate heat or smoke, rupture, or burst nto
flame.
• Do not solder directly onto the battery!
If the nsulator s melted or the gas release vent or safety
functon s damaged, the battery may generate heat or smoke,
rupture, or burst nto flame.
• Do not reverse the battery polarity (and terminals)!
When chargng a reversed battery, an abnormal chemcal
reacton may occur. In some cases, an unexpected large
amount of current may flow upon dschargng. The battery may
generate heat or smoke, rupture, or burst nto flame.