Kenwood TK-5320 - Manual (Page 16)

3
Do not use glue which is designed to prevent screw loosening when
installing the belt clip. Acrylic ester, which is contained in these
glues, may crack the transceiver’s back panel.
i
nStAlling the
c
Ap over the
u
niverSAl
c
onnector
i
nStAlling the
B
elt
c
lip
Attach the belt clip using the
supplied 3 x 8 mm screws.
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
transmission or when left sitting in
a hot environment.
Insert the cap into place over the
universal connector and secure
it in place using the attached
screw.
i
nStAlling the
(o
ptionAl
) S
peAker
/ m
icrophone or
h
eAdSet
1 Insert the guide of the
speaker/ microphone or
headset connector into place
over the universal connector.
2 Secure the connector in place
using the attached screw.
Note: When not using an optional
speaker/ microphone or headset,
install the cap over the universal
connector.
3 x 8 mm screws
Belt clip
1
2AB C
4
7
GH I 3 DEF
MIC
Universal
connector cap
1 ?
2 ? ABC ?
5 ? JKL ?
0 ?
8 ? TUV ?
4 ?
7 ?
GH I ?
PQRS ?
3 ? DEF ?
6 ? MNO ?
MIC ?
# ?
9 ? WXYZ ?
Optional
speaker/ microphone