Konica Minolta 7013 - Manual (Page 43)

2.12
Basic operation
Your machine’s copier features
Your machine has the following copier features:
• Single copy (see the right column on this page)
• Stacking multiple copies (see page 2.13)
• Sorting multiple copies (see page 2.13)
• Enlarged or reduced copies (see page 2.13)
• Negative/positive copy (Reverse black and white areas) (see page 2.17)
Basic copy procedure
1 Press COPY / FAX to change to
Copy mode.
When the machine is in the Copy mode, the LCD shows:
Note: For details about each item, see “Making copy settings,” pages
2.15–2.16
2 Place your original document in ADF face up, or on the platen glass face
down just as you would to send a fax.
3 Enter the document size by pressing the DOCUMENT SIZE .
4 As needed, set the following:
• Select document type and adjust image contrast
• Enter the number of copies
• Set copy reduction or enlargement ratio
Note: For details about each item, see “Making copy settings,” pages
2.15–2.16.
5 Press START .
Note: To reset the copy parameter to default setting, press COPY RESET .
Note: To stop the copying, press STOP .
Single copy
1 Press COPY / FAX to change to Copy mode.
2 Place your original document in ADF face up, or on the platen glass face
down just as you would to send a fax.
3 If you are using platen glass, enter the document size by pressing the
DOCUMENT SIZE .
4 As needed, set the following:
• Select document type and adjust image contrast
• Set copy reduction or enlargement ratio
Note: If you want to enlarge copy, use the platen glass.
5 Press START .
Copy Ready 1
A4 Auto 100%
Number of copies
Copy reduction or enlargement ratio
Recording paper size
Document size
COPY/FAX key
Making copies