Konica Minolta 7013 - Manual (Page 132)

“Check Message” printouts
When there’s a problem with a fax call and your machine detects an error, it pro-
duces an error printout headed by the words “Check Message.” This printout lists
the following information about the transmission:
• The resulting error code
• A communications error message (see “What error messages can mean,” below)
• The phone number (or
TTI , if programmed) of the fax machine with which your
machine had attempted to communicate.
What error messages can mean
The error messages on Check Message printouts can mean a variety of things.
Here’s a brief summary:
Error message Possible meanings
Check condition of remote fax. • Remote machine malfunctioned
• No “handshake” signals from remote fax
• Wrong phone number reached
Repeat transmission. • Poor phone line conditions
• No “handshake” signals from remote fax
• Document misfeed or miscount
• Unable to reach remote machine after
attempting specified number of redial tries
Line is busy. • Remote machine’s line was busy
• Remote machine’s line didn’t answer
Check received documents. • Remote confirmation signal not received
from remote fax
• Poor line conditions caused a poor image
Memory full. • Remote fax’s memory is full
Dialing number is not set. • Stored phone number failed to dial properly
Stopped. • Someone pressed STOP at the remote fax
in the middle of the “handshake”
Just in case …
5.11