Kodak EasyShare printer dock - Manual (Page 8)

Getting started
2 www.kodak.com/go/support
Finding a location for your printer dock
■ Place the printer dock on a flat, clean, dust-free surface, in a dry location,
and out of direct sunlight.
■ Allow 5 in. (12.7 cm) clearance on all sides of
the printer dock.
■ For proper ventilation, make sure the top and
back of the printer dock are not blocked.
■ When connecting power or USB cables, keep
the cables clear of the paper path to the front
and rear of the printer dock.
■ Avoid areas where ventilation ducts, open doors, or frequent passersby
might expose the printer dock and paper to high levels of dust and debris.
Airborne dirt particles can affect picture quality.
Installing the custom camera insert
The printer dock comes with a universal camera insert already installed. The
insert allows most Kodak EasyShare CX/DX6000/7000 series and LS600/700
series digital cameras to fit on the printer dock.
For best fit, use the custom camera insert that came with your camera and
keep the universal camera insert as a spare.
NOTE: For some cameras, you must use the custom camera insert to dock the camera, otherwise
the camera will not fit properly on the printer dock.
1 Remove the universal camera insert:
a Push the insert toward the back of the
printer dock and lift up the front edge.
b Lift up the back edge of the insert and
remove.
2 Install the custom camera insert included with
your camera:
a Place the rear tabs of the insert in the slots
toward the back of the printer dock.
b Press the front of the insert down and snap
into place.