Konica Minolta Q-M200 - Manual (Page 27)

* The viewfinder LED lights red after a flash
photograph is taken to indicate that the flash is
charging. Wait until the viewfinder LED turns
off before taking the next flash photograph.
Selftimer Button
This button enables the camera to release the
shutter automatically and is used when the pho-
tographer wishes to be included in the photograph.
Since it is necessary to keep the camera stable
when the selftimer is used, the use of a tripod is
recommended. In the initial setting, the shutter will
release approximately 10 sec. after the shutter
button is pressed.
1. Set the mode select dial to Photo ( ).
Note:
* When the power is already turned on with Play-
back ( ) or set up (SET UP), set the mode
select dial to Photo ( ) to cancel these two
modes and open the lens cover automatically.
2. Press the power button.
The lens cover will open automsatically.
3. Press the selftimer
button ( ). The self-
timer mark ( ) will ap-
pear in the data display
panel and the selftimer mode will be activated.
4. Gently press the shutter button fully.
The selftimer LED on the
front of the camera will
start to blink. Approxi-
mately 10 sec. later the
shutter will release.
Notes:
* Press the selftimer button a second time to
cancel the selftimer while it is operating.