Konica Minolta Q-M200 - Manual (Page 25)

Flash Mode Button
It is possible to preset the flash for situations
where it is anticipated that sometimes there may
be insufficient light for normal photography.
The flash range is 1.0 m-3.0 m. If the flash is used
with subjects closer than this distance the photo-
graph will be too light; if used beyond this range,
the photograph will be too dark.
1. Set the mode select dial to Photo ( ).
Note:
* When the power is already turned on with
Playback ( ) or set up (SET UP), set the
mode select dial to Photo ( ) to cancel these
two modes and open the lens cover automati-
cally.
2. Press the power button.
The lens cover will open
automatically.
3. Press the flash mode button ( ).
Each time this button is pressed, the data
display panel will change as indicated below.
Auto Flash (initial Setting)
[ AUTO]
The camera senses the
light conditions and deter-
mines whether or not flash is necessary.
↓
Redeye Reduction/
Auto Flash
[ AUTO
]
The camera senses the light
conditions and determines whether or not flash is
necessary.
Pre-flashes are fired before the main flash to re-
duce the redeye effect.
↓