Konica Minolta Q-M200 - Manual (Page 12)

Setting the Date and Time
Set the date and time when using the camera for
the first time after purchase. Setting is possible
from January 1, 1970 to December 31, 2037.
In this example, set the date and time from Janu-
ary 1, 1999 (0:00) to September 3, 2000 (10:30).
Note:
* The date and time settings are powered by the
backup battery and are not lost when the cam-
era batteries are replaced. The life of the
backup battery is about 2 years.
1. Make sure that fully charged batteries are
loaded or the AC adapter is connected.
2. Set the mode select dial
to SET UP and then
press the power button.
The LCD monitor will light
and the setup screen will appear with “Format”
selected. (*1)
Notes:
* When the power button is pressed for the first
time after purchase, step 4 of the date and time
setting screen will appear.
* When the power is already turned on with
Playback ( ) or Photo ( ), set the mode
select dial to set up (SET UP) to cancel these 2
modes the LCD monitor will light automatically.