Konica Minolta bizhub 163 - Manual (Page 70)

Network printing 3
IC-206 3-5
3.2 Checking the setup
This section provides an overview of the setup procedure that is required for
each network printing method.
Peer-to-peer printing
1
Connect the network cable. (Refer to “Connecting to a local area net-
work (LAN)” on page 1-12.)
2
From the machine’s control panel, specify the IP address, subnet mask
and default gateway. (Refer to “Specifying an IP address” on page 3-9.)
3
Print the settings information, and then check the settings. (Refer to
“Printing the settings information” on page 3-13.)
4
Install the printer driver. The Peer-to-Peer Utility is installed when the
printer driver is installed.
– For details on installing the PCL driver, refer to “Installing the printer
driver by using the Add Printer Wizard” on page 2-15.
– If the GDI driver is to be installed, refer to the User’s Guide for the
GDI printer controller, included with this machine.
5
Add the network port to the computer. (Refer to “Connecting the com-
puter and this machine over a network” on page 3-15.)
2
Reminder
When installing the printer driver on an operating system other than Win-
dows 98 SE or Windows Me, the Peer-to-Peer Utility is not installed.