Networking your printer, Connecting to a wireless network, Before you connect – Kodak ESP 5200 User Manual
Page 10: Connecting to a non-wps wireless router, 2 networking your printer
www.kodak.com/go/aiosupport
5
2
Networking Your Printer
This section explains how to configure or change your network settings.
Connecting to a wireless network
To connect your printer to an 802.11b/g wireless (Wi-Fi) network, refer to the
following information.
Before you connect
You need:
• a wireless router.
• to determine whether your wireless router supports Wi-Fi Protected Setup
(WPS).
NOTE: If you have specific questions about your router, see your router
manufacturer’s documentation for more information.
Connecting to a wireless network using the WiFi Setup Wizard
You can use the WiFi Setup Wizard on the printer to connect to your wireless
network. Use the procedure that is appropriate for your network setup.
Connecting to a non-WPS wireless router
To connect your printer to your wireless network, you need to know the network
name, also called the Service Set Identifier (SSID). You can obtain your network
name from the wireless router.
If your network has security enabled, you also need to know the password
(passphrase or security string).
Record your network information in the spaces below, using the correct uppercase
and lowercase letters.
Network Name (SSID):_____________________________________________________
Security String: ___________________________________________________________
1. Press
Home.
2. Press
to select
Network Settings, then press OK.
3. With
WiFi Setup Wizard selected, press OK.
NOTE: The Wi-Fi radio turns on when you select Wi-Fi Setup Wizard.