Kenwood HM-535 - Manual (Page 37)

Timer operation
37 EN
As the clock is not only used to show the time of the day but also used in timer operations, be sure to set
the clock in advance.
Clock adjustment
Adjust the hour.
1
Select the figure of hour.
2
Set it.
2
To decrease
hour To increase
hour
Example: Adjustment to 8:07
Activate the Clock adjustment mode.
1
÷ The time display starts to blink.
÷ In other areas than the U.K. and Europe the clock
shows the time of the day in the 12-hour system.
÷ Press the set/demo key. The hour is entered and the
minute display starts to blink.
Adjust the minute.
1
Select the figure of minute.
2
Set it.
3
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
set/demo key, the display shows "COMPLETE".
÷ After a power failure or the power cord has been un-
plugged, the time set will be erased. You have to set
the time again when unit is switched on.
÷ When the 7 key is pressed while the power is in the
standby mode, the time of the day will be displayed for
5 seconds.
Example: Adjustment to 8:07
To decrease
minute To increase
minute
\ \ \ \
1
Select " TIME ADJUST ?"
(Press the set/demo key while the "?" mark is
blinking.)
5240/36-42/EN 3/9/02, 7:25 PM 37