Kenwood HM-535 - Manual (Page 35)

Convenient recording methods
35 EN
Desired CD tracks can be programed in the desired sequence and recorded onto a tape.
Make preparation for recording.
Be sure to put the cassette deck in stop mode.
1
Select the CD input.
2
Ensure that the "RDM" indicators are not lit.
3 Perform steps 1 to 3 of the procedure in "Recording on TAPE". §
4
Insert disc in the CD player.
1
÷ If the "RDM" indicator is lit, turn it off by pressing the RANDOM key to cancel the random play mode.
Program recording
(CD
=
TAPE)
Program the desired sequence of CD tracks.
2
Perform steps 1 and 2 of the procedure in "Lis-
tening to the desired sequence (program play-
back)".
ª
÷ When the PGM key is pressed to cancel the edited con-
tents, the entire editing contents will be erased. º
÷ Tracks programed beyond the available tape recording
time will be interrupted in the middle.
Start recording.
3
To interrupt a recording
(Recording and playback will be stopped)
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
÷ Recording starts from the first track in the program and
ends after having recorded the entire programed
tracks.
÷ Recording stops automatically when the program play-
back of CD has completed.
÷ When either playback or recording stops, the other op-
eration is stopped automatically.
The tape deck of the unit can record signals only on Normal (Type ) tapes. It cannot record on High (Type ) and
Metal (Type
) tapes.
If you are operating the remote, the same effect as
step 3 can be obtained by simply pressing the
O.T.E. key to start recording.
5240/33-35/EN 3/9/02, 7:24 PM 35