Kenwood HM-535 - Manual (Page 34)

Convenient recording methods
34 EN
Records all tracks in a CD with a simple operation. (All-track recording)
Records a single CD track being played from the beginning. (Single-track recording)
Make preparation for recording.
Be sure to put the cassette deck in stop mode.
1
Perform steps 1 to 3 of the procedure in "Recording on TAPE". §
2
Ensure that the "PGM" and "RDM" indicators are not lit.
3
Insert disc in the CD player.
1
÷ If the "PGM" indicator is lit, turn it off by pressing the PGM key in stop mode to cancel the program mode.
÷ If the "RDM" indicator is lit, turn it off by pressing the RANDOM key to cancel the random play mode.
Check the current play mode of the CD player.
2
Select the desired CD track and play it. If it is in play mode, stop it.
All-track recording Single-track recording
÷ When step 3 is performed in the middle of CD play-
back, the current track will be recorded from the begin-
ning.
Start recording.
3
÷ When either playback or recording stops, the other op-
eration is stopped automatically.
(To record other tracks, repeat steps 2 and 3 for each
track)
To interrupt a recording
(Recording and playback will be stopped)
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec.
has been produced.
If you are operating the remote, the same effect
as step 3 can be obtained by simply pressing the
O.T.E. key to start recording.
One-touch edit recording
(CD
=
TAPE)
The tape deck of the unit can record signals only on Normal (Type ) tapes. It cannot record on High (Type ) and
Metal (Type
) tapes.
5240/33-35/EN 3/9/02, 7:24 PM 34