KORG EasyStart microX - Manual (Page 29)

Functions specific to the editor
26
Export
Saves data from the editor as PCG data for the TRITON series or KARMA.
Note: These functions allow flexible data exchange between the microX/X50 and the Korg
TRITON series or KARMA. For details, refer to “Data compatibility between the microX/X50
and the Korg TRITON series or KARMA Music Workstation” (
☞p.27).
Save Default
Writes the current GLOBAL [Software Setup] settings of the editor so that they will be the
default values when you start up the editor.
Restore Data
Restores the microX/X50’s data to the state in which it was when the editor was connected
(started up). You can execute this command if you’ve deleted data accidentally.
Note: When you start up the editor, it will synchronize its own state with the data currently in
the microX/X50. The data the editor receives at this time is held as backup data until you
close the editor.
Note: These utility commands can be selected only from the GLOBAL [Software Setup] page
of the editor.
Parameters
You can set the following parameters in the GLOBAL [Software Setup] page.
Total Recall Data Setting
This specifies the editor data that will be saved and loaded as part of the song data by your
DAW software. You can make these settings to specify that only specific types of data will be
saved or loaded.
Note: This function is available only in the microX/X50 Plug-In Editor.
Auto Local Control
This setting automatically sets the microX/X50's Local Control setting to the appropriate state
when you start up the editor. We recommend that you normally leave this parameter on. The
microX/X50’s Local Control setting will be reset to its original state when you close the edi-
tor.