KORG EasyStart microX - Manual (Page 15)

Setup
12
Steinberg - Cubase SX3
1 Start up Cubase SX3 and create a project.
2 In the VST Instruments window, start up “microX/X50 Plug-In Editor.”
3 Create a MIDI track. As the output of that MIDI track, choose “microX/X50 Plug-In
Editor” which you started up in the VST Instruments window.
4 To route the microX/X50’s audio signal to Cubase SX3, create an audio track. As the
input of the track, select the audio interface input to which you’ve connected the
microX/X50’s audio signal.
5 Turn the Monitor button on so that you can hear the audio signal.