KORG EasyStart microX - Manual (Page 28)

Functions specific to the editor
25
Functions specific to the editor
These are functions that are not found on the microX/X50, and are available only from the
editor (microX/X50 Editor, microX/X50 Plug-In Editor).
Utility commands
Load
Loads editor data that was previously saved on the computer.
Save
Saves data from the editor to your computer as a file.
Note: These functions load or save the data as dedicated files for the editor application. Data
can also be loaded between the microX and X50. If you do so, multisamples and drum sam-
ples will automatically be rearranged as necessary. When you load an X50 file into the
microX, all programs of program bank E and all external control setup data will be filled with
initialized data.
Receive All
Receives all data from the microX/X50 data into the editor.
Transmit All
Transmits all data from the editor to the microX/X50 and writes it.
Receive Combi/Multi/Prog/Drum Kit/Arp. Pattern/Ext. Control/Glo-
bal data
Receives the corresponding data from the microX/X50 into the editor.
Transmit Combi/Multi/Prog/Drum Kit/Arp. Pattern/Ext. Control/
Global data
Transmits the corresponding data from the editor to the microX/X50 and writes it.
Receive 1 Combi/1 Multi/1 Prog
Receives the corresponding data from the microX/X50 into the editor.
Transmit 1 Combi/1 Multi/1 Prog
Transmits the corresponding data from the editor to the microX/X50. This operation will not
write the data into the microX/X50’s memory.
Note: These Receive and Transmit commands use KORG SysEx MIDI Dump to send or
receive data, or to synchronize the data between the microX/X50 and the software.
Don’t touch the keyboard or the mouse of your computer while data is being sent or
received. Also, don’t touch the panel switches or the keyboard of the microX/X50.
Import
Loads PCG data from the TRITON series or the KARMA Music Workstation into the editor.