Kenwood TK-5410 - Manual (Page 39)

2
■
Identification Codes
An ID code is a combination of a 3-digit Fleet number and
a -digit ID number. Each transceiver must have its own
Fleet and ID number.
• Enter a Fleet number (00 ~ 3) to make a group call.
• Enter an ID number (000 ~ ) to make an individual call in
your fleet.
• Enter a Fleet number to make a call to all units in the selected
fleet (Fleet call).
• Enter an ID number to make a call to the selected ID in all
fleets (Supervisor call).
• Select “ALL” Fleet and “ALL” ID to make a call to all units
(Broadcast call).
Note: The ID range may be limited by programming.
S
tAtuS
m
eSSAge
(k2/k3/k5/k6/k7
modelS only
)
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to
alphanumeric characters. Status messages range from 0 to
(80 ~ are reserved for special messages).
A maximum of received messages can be stored in the
stack memory of your transceiver. These saved messages
can be reviewed after reception. Depending on your dealer
settings, when the stack memory is full, either the oldest
message will be erased when a new message is received or
the new message will not be stored in the stack memory. The
icon lights when a message is stored in the stack memory.