Samsung SHR-1041 - Manual (Page 15)

English _1
●
instaLLation
connecting to the internet
Connect LAN cable of Cable/ADSL modem or Direct Fixed/Static IP LAN Line to WAN port of IP Router.
Connect LAN ports of IP Router to Ethernet port SHR-1041 to be set up and to Ethernet port of Local PC
to use during setup.
Connect Video cable of Camera to Monitor.
Turn on the Monitor power.
If you have a Static (Fixed) IP line or Dynamic IP line (Cable Modem or ADSL Modem) with one IP address (whether its
dynamic or fi xed), but have more than one internet device to use (such as a PC and a SHR-1041 or several SHR-1041);
you must use an IP Router (different from a simple Network Hub); You must set up the Router to work with the
SHR-1041 and you must use a network capable PC within The local Router network to do the setup.
If you are using an existing Router which is already set up, you may not need to redo the basic setup of the Router
again, but it is highly recommended that you at least read all the instructions below and go through the steps.
Whether you are using an existing Router or a new Router, you must go through the Port Forwarding portion of the
setup.
1.
.
.
.


DIGITAL VIDEO RECORDER SHR-1041 POWER ALARM REC NETWORK
DISPLAY SEARCH MENU
Data Line :
Video Line :
CAMERA
LOCAL PC #1
IP Router or HUB Cable/ADSL Modem
Direct LAN (Fixed/Static IP)
SHR-1041
Internet
or
LOCAL PC #2
02235A_SHR-1041K_ENG.indb 15 2009-02-17 오전 10:50:29