Symbol Technologies DS6707 - Manual (Page 85)

SSI Interface 6 - 3
Simple Serial Interface Default Parameters
Table 6-1 lists the defaults for the SSI host. There are two ways to change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
Set Default Parameter on page 4-4 .
• Download data through the device’s serial port using SSI. Hexadecimal parameter numbers are shown in
this chapter below the parameter title, and options are shown in parenthesis beneath the accompanying
bar codes. See the Simple Serial Interface (SSI) Programmer’s Guide for detailed instructions for
changing parameters using this method.
NOTE
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies,
and miscellaneous default parameters.
Table 6-1 SSI Interface Parameter Defaults
Parameter
Parameter
Number
Default
Page
Number
Baud Rate 9Ch 9600 6-4
Parity 9Eh None 6-6
Check Parity 97h Enable 6-7
Software Handshaking 9Fh ACK/NAK 6-7
Host RTS Line State 9Ah Low 6-8
Decode Data Packet Format EEh Send Raw Decode Data 6-8
Stop Bits 9Dh 1 6-9
Host Serial Response Time-out 9Bh 2 sec 6-10
Host Character Time-out EFh 200 msec 6-11
Multipacket Option F0h 4Eh Option 1 6-12
Interpacket Delay F0h 4Fh 0 ms 6-13
Event Reporting
Decode Event F0h 00h Disable 6-14
Boot Up Event F0h 02h Disable 6-15
Parameter Event F0h 03h Disable 6-15
NOTE
SSI interprets Prefix, Suffix1, and Suffix2 values listed in Table A-1 on page A-1 differently
than other interfaces. SSI does not recognize key categories, only the 3-digit decimal value. The
default value of 7013 is interpreted as CR only.