Introduction, Introduction -1, Chapter 4 – Symbol Technologies DS6707 User Manual
Page 43
Chapter 4
User Preferences & Miscellaneous Digital
Imager Scanner Options
Introduction
If desired, program the digital imager scanner to perform various functions, or activate different features. This
chapter describes each user preference feature and provides the programming bar codes necessary for
selecting these features.
The digital imager scanner ships with the settings shown in the
(also see
Appendix A,
Standard Default Parameters
for all host device and miscellaneous defaults). If the default values suit
requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the digital imager scanner is powered down.
If not using a USB cable, select a host type after the power-up beeps sound. (See
Chapter 6, SSI Interface
Chapter 7, USB Interface
and
Chapter 8, RS-232 Interface
for specific host information.) This is only
necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
Set Default Parameter on page 4-4
. Throughout the
programming bar code menus, default values are indicated with asterisks (
*
).
NOTE
Most computer monitors allow scanning the bar codes directly on the screen. When
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.
*
High Volume
(00h)
Feature/Option
*
Indicates Default
Option Hex Value for
programming via SSI
command
Chapter 4
User Preferences & Miscellaneous Digital Imager Scanner Options