Now you can see – SVAT Electronics CLEARVU3 User Manual

Page 54

SVAT ELECTRONICS

now you can see

CLEARVU3

No picture/signal

Make sure your TV/monitor is on the correct video input

channel. This is NOT channel 3. Common terms for this channel
is INPUT, AV CHANNEL, LINE 1, LINE 2 and AUX. Please use
your TV or VCR manual to correctly identify this channel.

If your camera is connected to a VCR/DVR, make sure that

it is properly connected to your TV/monitor.

Check all connections to make sure they are secure and

properly connected.

Check your power supply to ensure that the camera is

powered up.

Picture is too bright

Make sure your camera is not aimed at direct sunlight.

Adjust the sunshade by sliding it forwards to block out

excess light.

Make sure nothing is obstructing the CDS sensor on the

camera. If the CDS sensor is blocked, night vision mode will be

active and may produce extra light in your camera’s picture.

Move your camera to another location.

Picture is too dark

If using at night, make sure your camera’s subject is

no more than 15ft away (may vary based on amount of

ambient light available).

If using during the day, your camera may not be getting

enough light. Adjust the sunshade by sliding it backwards to

let in more light.

Check the brightness and contrast settings on your TV/monitor

If your camera is connected to a VCR/DVR, check the

brightness and contrast settings on the VCR/DVR

Move your camera to another location.

Plug the camera’s power

supply into the power jack
located on the 60ft video/
power wire.

. Plug the camera’s power

adapter into an AC outlet.

Connect the 60ft video/
power wire’s male RCA

plug to the VIDEO IN port of
your TV/ monitor/VCR/DVR.

If your VIDEO IN port is a
BNC connection (common
with DVR units), you will
need to attach the BNC
to RCA adapter before

connecting the camera.

14.2.2 Troubleshooting