Savin SLP 38c SLP38C - Manual (Page 13)

7
2. Windows 95/98/Me
Configuration
Printing with a Print Server
Printing with a Windows 2000 or Windows NT 4.0 Print Server
This section describes the procedures for setting up a client on a network that
uses Windows 2000 Server, Windows 2000 Professional, Windows NT 4.0 Server
or Windows NT 4.0 Workstation as a print server.
To print from Windows 95/98/Me, you must install the printer driver and
change the printer port to the print server.
Preparation
If you print with a print server, select [Typical] installation.
The PCL 5c and RPCS printer driver can be installed by [Typical] installation.
This section assumes that the client has already been configured to communi-
cate with a Windows 2000 or Windows NT 4.0 print server. Do not begin the
following procedure until the client has been set up and configured correctly.
A
Close all applications that are running.
B
Insert the CD-ROM into the CD-ROM drive.
The installer will start by Auto Run.
Important
❒ Never have two versions of the same printer driver installed on your sys-
tem at the same time. When upgrading to a new version of the printer driv-
er, delete the old version, and then install the new one.
Windows 95/98/Me
Windows 2000
Windows NT 4.0
Print Server