Sharp AR-FX12 - Manual (Page 77)

PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES
6-13
6
SETTING FOR F-CODE RELAY BROADCAST MEMORY
BOXES (RECIPIENT)
Program the end receiving machines to which document data received in the F-code relay broadcast memory box
will be transmitted when your machine is a relay machine.
Up to 30 end receiving machines can be programmed. If you attempt to program more than this number, a message
will appear and programming will not be possible.
1 Touch the [RELAY BROADCAST] key in
step 3 of "PROGRAMMING AN F-CODE
MEMORY BOX" on pages 6-10 to 6-11 and
store a box name, sub-address, and
passcode.
2 Touch the [RECIPIENT] key.
The address selection
screen appears.
3 Touch the one-touch keys you wish to
include as end receiving machines.
Touch indexes and the
keys as
needed.
The selected one-touch keys are highlighted and
programmed as end receiving machines.
If you touch an incorrect key, touch the key again to
remove the highlighting and delete the destination.
You can also use the [
] key (speed dial key) to
store a one-touch key. (See "SENDING A FAX BY
SPEED DIALING" on page 2-4.)
To enter a fax number that has not been stored in
a one-touch key, to enter a full fax number with the
numeric keys, touch the [DIRECT ENTRY] key and
then the [FAX] key and enter the fax number.
Enter the fax number and then a sub-address and
transmission settings (if desired) as explained in
steps 10 to 13 and 15 of "STORING ONE-TOUCH
DIAL KEYS" on pages 6-3 to 6-4, and then touch
the [OK] key twice to return to the screen of step 3.
4 To check the destinations that have been
selected as end receiving machines, touch
the [ADDRESS REVIEW] key.
The destinations
selected as end
receiving machines are
displayed.
You can delete a
destination by touching
it. When the
confirmation message appears, touch the [YES]
key to delete the destination.
5 Touch the [OK] key in the screen of step 3.
You will return to the screen of step 2 and the
number of stored as end receiving machines will
appear.
6 To exit, touch the [EXIT] key. To program
another memory box, touch the [NEXT] key.
Touching the [EXIT] key returns you to the screen
of step 3 on page 6-10.
Touching the [NEXT] key returns you to the screen
for programming a new memory box (the screen of
step 4 on page 6-10).
SUB ADDRESS
BOX NAME FAX INFORMATION
123456/987654
RECIPIENT
1/1 A B
F-CODE MEMORY BOX / RELAY BROADCAST
SELECT ADDRESS.
DANIEL ERNY
FREQUENT USE ABCD EFGHI JKLMN OPQRST UVWXYZ
* 2
OK
DIRECT ENTRY
ADDRESS REVIEW
ABC GROUP
C GROUP CLIFF QUIROGA
JKLMN OPQRST UVWXYZ
OK
DIRECT ENTRY
ADDRESS REVIEW
GROUP ABC
FAX
E-MAIL
INTERNET-FAX
OPQRST UVWXYZ ABC GROUP
ADDRESS REVIEW
DIRECT ENTRY
OK
1/2
* 0