Sharp AR-FX12 - Manual (Page 40)

3-10
FAXING A LARGE NUMBER OF
PAGES (JOB BUILD MODE)
The maximum number of pages that can be loaded in the automatic document feeder is 50. When you need to fax
more pages than can be loaded in the automatic document feeder, use Job Build mode. This function allows you to
scan the pages in sets.
If the memory becomes full while scanning the pages, a message will appear. To cancel the transmission, touch
[CANCEL]. To transmit only the pages that have been scanned, touch [SEND].
Example: Scanning 100 A4 (8-1/2" x 11") size pages
1 In fax mode, touch the [SPECIAL MODES]
key and then touch the
key.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-5).
2 Touch the [JOB BUILD] key.
The [JOB BUILD] key is
highlighted.
To cancel the selection,
touch the key once
again so that it is not
highlighted.
3 Touch the [OK] key.
You will return to the
screen of step 1.
4 Place the original in the automatic
document feeder. (See page 1-7.)
5 Follow steps 4 through 7 of "BASIC
PROCEDURE FOR SENDING FAXES".
(See pages 2-2 to 2-3.)
6 Press the [START] key.
The pages are scanned.
When scanning is
finished, the
[READ-END] key
appears in the touch
panel.
7 Place the next set of pages in the automatic
document feeder. (See page 1-7.)
8 Press the [START] key. (See step 6.)
9 Repeat steps 7 and 8 until all pages have
been scanned, and then touch the
[READ-END] key.
* Divide the original pages into sets of 50 pages or less, and
scan the sets in order beginning from the set with the first
page (first A then B in the above example).
50 pages 50 pages
Page 1 Page 51
Original
TO RECEPTION
MEMORY:100%
QUICK FILE
ADDRESS REVIEW
SPECIAL MODES
FILE
SUB ADDRESS
MODE SWITCH
MEMORY BOX
FAX O
SE
JOB
BUILD
SPECIAL MODES
SPEAKER RESEND
OK
DUAL PAGE
SCAN