SBE HighWire HW400c/2 User Manual

Page 90

HighWire HW400c/2 User Reference Guide Rev 1.0

keystroke will stop the countdown and drop into the U-boot debug
shell.

baudrate

Baud rate of the HW400c/2 console (debug) port

unit’s MAC address.

he MAC address is assigned by SBE at the time of manufacture, stored in non-volatile memory, and

ress will be ignored.

n dot notation. If not used,

ing bootp, this

address is ignored.

The tftp server’s IP address in dot notation. If not used, should be set
to 0.0.0.0 for clarification. When using bootp, this address is

ot used, should

, this address is

etmask

This unit’s netmask in dot notation. If not used, should be set to
0.0.0.0 for clarification. When using bootp, the mask is ignored.

Fixed environment variables.

These variables will be displayed and cannot be changed.

ard).

serial

Destination of the HW400c/2’s standard output (terminal screen).
Default= Cannot be deleted (debug port).

stderr

Destination of the HW400c/2’s standard error (console error
messages). Default=serial (debug port).

ethact

Active MAC port. Default=mv_eth0

ethaddr

This

T
must not be altered. Any attempt to change the MAC add

ipaddr

This unit’s static IP address (if used) i
should be set to 0.0.0.0 for clarification. When us

serverip

ignored.

gatewayip

The gateway system’s IP address in dot notation. If n

be set to 0.0.0.0 for clarification. When using boo
ignored.

stdin

Source of the HW400c/2’s standard input (keybo
Default=

(debug port).

stdout

October 10, 2006

Page