SBE HighWire HW400c/2 - Manual (Page 41)

HighWire HW400c/2 User Reference Guide Rev 1.0
3 ernet Ports .4.4 PT5MC Eth
Each of the two PT5MC sites on the HW400c/2 have two 10/100/1000 Mbps ports
connected to the Ethernet switch. The signals conform to PICMG ECN 2.15-1.0-
001, using the first 24 pins of the respective JN4 connectors.
pactPCI J3 connector using a
FET switch specially designed for signals such as Gigabit Ethernet. The PTID bits
ontrol the FET, when a PT5MC module is installed in either mezzanine card site.
at
N4 pins 5, 6, 11, 12, 17, 18, 23 and 24 are switched to ground through discrete FETs
t the JN4 connector when a PT5MC module is installed. This has the effect of
CompactPCI J5 connector as well, so
aution must be exercised not to damage circuitry on an installed RTM.
r
.4.5 CompactPCI Packet Switch Backplane (cPSB) Ports
Two of the 10/100/
and Port 1, are
uted to the CompactPCI J3 connector as specified for Packet Switching Backplane
(PSB) in PICMG 2.16. See Table 14 and Table 15. The HW400c s configure
PCIG 16 Node c
3.4.5.1 CompactPCI Connector J3, pow and ground
The H 400c/2 us of the J3 , designa the PIC 16 as U ,
as po and grou in order vide eno rrent to e some
more er hungr cards. power pins cannot be disconnected. This can
dam o some Re nsition M (RTM BE ass power a
grou ins are shown in bold in T
The JN4 Ethernet connections are switched to the Com
c
Should a non-PT5MC module be installed in one of the sites, the JN4 signals for th
site are routed to the CompactPCI J5 connector as user I/O according to PICMG 2.3
R1.0.
J
a
!
grounding the respective connections at the
c
! PT5MC cards with network connections through Pn4, must be transformer coupled o
the link to the layer 2 switch will not be established.
3
1000BaseT ports of the Ethernet switch, Port 0
ro
/2 i d as a
2. ard.
er
W
we
es some
nd pins
pins
to pro
t ed by
ugh cu
MG 2
handl
. ser I/O
of the r
pow y PTMC T
odules
hese
age t ar Tra ). The S igned nd
nd p able 15.
!
October 10, 2006 Copyright 2006, SBE, Inc. Page 29