Sony SRP-X700P - Manual (Page 15)

15
2-3 (3) Setup for “Tow Rooms (Independent) Operation” of X700P Manager GUI
To assign line sources to the
Front Speakers.
No assignment of mic signals
for less feedback.
The Sub-system has no
satellite speakers in this usage.
No assignment of LINE2
(a signal from main system)
because of the Independent
Operation.
5 mic signals are assigned to
OUTPUT-7 (internal 70V
amp).
No assignment of LINE2 to a recorder.
Instead of this assignment, mic signals are assigned to RECOUT-1,
line sources are sent to RECOUT-2, for clearer sound in reproduction.
To open OUTPUT SCREEN of the Sub X700P
Select 70V LINE in the MODE box. (In case of selecting the
70V LINE, CH 2 box is closed because 70V operation sets the
internal amplifier to MONO).
To select OUTPUT7 on the SELECT box. Attenuation is set
by adjusting sound level of listening area. No MUTING.
To open OUTPUT SCREEN of the Sub X700P
(b) To select 1 for SCENE No.
And memo about operation, etc.
(c) Check buttons including
ROUTING.
(d) Press button to STORE.
The INFORMATION box may be used to provide more detailed information.
(There is not a separate INFORMATION box for each SCENE MEMORY.)
As in setup of the Main System,
the SCENE No.1 is selected.
(B) SETUP of Sub X700P for “SCENE MEMORY-1”
To open ROUTING SCREEN of the Sub X700P
(a) To avoid inadvertent operation, scene recall buttons of front
panel are not recommended to use. The Control Box is
recommended to recall.