Sun Microsystems SUN NETRA CP3000 - Manual (Page 22)

1-12 Sun Netra CP3000 Advanced Mezzanine Card PCIe Hard Drive and SAS Controller User’s Guide • March 2010
Caution – Failure to fill all slots with AMCs or cover with filler panels can
negatively impact the cooling of the system.
1.6.2 Removing a Blade Server and AMC
Following are the instructions for removing a blade server and installed AMC. For
additional information, refer to your blade server documentation.
Caution – Before removing a blade server and AMC, read all cautions, warnings,
and instructions presented earlier in this chapter.
1. Move the front cable management bracket to the lower position ( FIGURE 1-4 ).
FIGURE 1-4 Front Cable Management Bracket in Lower Position
2. Disengage the injector/ejector mechanisms at the top and bottom of the blade
server to notify software that the board is about to be removed. Wait for the
Hot-Swap LED to light.