Sun Microsystems SUN NETRA CP3000 - Manual (Page 19)

Chapter 1 Getting Started 1-9
Note – Depending on how the Shelf controls deactivation, the Shelf might not
initiate deactivation when you disengage the ejector latch. If so, either configure the
Shelf to allow deactivation via latch opening or deactivate by other methods.
4. For the AMC, initiate the hot-swap deactivation sequence by pulling the
injector/ejector latch out half way ( FIGURE 1-2 ).
The Hot-Swap LED starts blinking.
5. Wait until the Hot-Swap LED is solid blue.
6. When the Hot-Swap LED is solid blue, pull the injector/ejector latch out
completely ( FIGURE 1-2 ).