Sun Microsystems SUN NETRA CP3000 - Manual (Page 11)

1-1
C H A P T E R
1
Getting Started
This chapter provides information and procedures needed to install and make the
Sun Netra CP3000 AMC.1-HDD SAS disk operational. This chapter should be read
before unpacking and installing the AMC.
In addition to this chapter, refer to the following safety document:
Important Safety Information for Sun Hardware Systems (816-7190)
Caution – When the system is plugged in, energy hazards are present on the
midplane. Do not reach into the enclosure while the power is on.
Caution – Static electricity can damage electronic components. Wear a wrist strap
grounded through one of the system’s ESD ground jacks when removing and
replacing hot-swappable components.
This chapter contains the following topics:
■ Section 1.1, “System Requirements” on page 1-2
■ Section 1.2, “Unpacking” on page 1-3
■ Section 1.3, “Handling AMCs” on page 1-4
■ Section 1.4, “AMC Faceplate” on page 1-5
■ Section 1.5, “AMC LEDs” on page 1-6
■ Section 1.6, “Removing and Installing AMCs” on page 1-8
■ Section 1.7, “Enabling and Disabling SAS Ports” on page 1-18