Simrad EQ60 User Manual
Page 58
Simrad EQ60
46
857-164342 / Rev.C
3
Click the desired entry in the Frequency Channel
Selection list.
4
Select the alternative NONE in the Transducer Selection
list.
5
Click OK to accept the choice and exit the dialogue box.
6
Restart the echo sounder as described below.
Related topics
→
Transceiver Installation, page 112
To modify an IP address
This procedure allows you to modify the IP address of the
currently selected General Purpose Transceiver (GPT).
1
Select Transceiver on the Install menu.
2
Select Modify in the Transceiver Installation Mode
dialogue box.
- The Transceiver Installation dialogue box opens, and
you are allowed to make changes.
3
Select the General Purpose Transceiver (GPT) you wish to
modify.
4
Click the Set New GPT IP Address button.
- The
IP Address
dialogue box opens.
5
Enter the new IP address.
- The significance of the address numbers is described
with the
IP Address
dialogue box.
6
Click OK to accept the choice and exit the dialogue box.
7
Click OK to exit the Transceiver Installation dialogue
box.
8
Restart the echo sounder as described below.
Related topics
→
Transceiver Installation, page 112
→
IP Address, page 91
Restart the echo sounder
Whenever a change has been made to any of the frequency
channels, you must restart the echo sounder.
1
Select Operation on the File menu.
- The Operation dialogue box opens.
2
Select Normal operation, and click OK.
Related topics
→
Operation, page 97