Siemens C2-010 - Manual (Page 24)

C2-010 / C2-010-I ADSL2+ Router User’s Guide
4-12
4.3 DHCP Configuration
To display the DHCP Server menu, click the DHCP button in the Home directory. Active DHCP Clients
appear listed in the DHCP Client Table below the configuration menu. Information about DHCP clients
includes the IP address, MAC address, host name and lease time are displayed in the list.
Figure 4-8. Configure DHCP server settings for the LAN
The three options for DHCP service are as follows:
You may use the ADSL2+ Router as a DHCP server for your LAN.
You can disable DHCP service and manually configure IP settings for all workstations.
You will use a DHCP service provided by your ISP, in which case DHCP should be disabled on the
ADSL2+ Router.
4.3.1 DHCP Server Settings for the LAN
The default setting of ADSL2+ Router 's DHCP server is disabled. While you click to select the Enabled
radio button under the DHCP Server option, the device will become the default gateway for DHCP clients
that connected to it. When the ADSL2+ Router is used for DHCP it becomes the default gateway for DHCP
client connected to it. Keep in mind that if you change the IP address of the ADSL2+ Router, you must
change the range of IP addresses in the pool used for DHCP on the LAN.
4.3.2 Use the ADSL2+ Router for DHCP
To use the built-in DHCP server, click to select the DHCP Server option if it is not already selected. The
IP Address Pool settings can be adjusted so that up to 253IP addresses are available for use. The Starting
IP Address is the lowest available IP address (default = 192.168.1.2). If you change the IP address of the
ADSL2+ Router this will change automatically to be 1 more that the IP address of the ADSL2+ Router. The
Ending IP Address is the highest IP address number in the pool (default = 192.168.1.33). Select the Lease
Time from the pull-down menu. This is the amount of time that a workstation is allowed to reserve an IP
address in the pool if the workstation is disconnected from the network or powered off. Lease time options
vary from 1 hour to 1 week. DHCP client workstations on your LAN must be properly configured to use
DHCP service. Be sure to save the new settings.